Can-Am X3 Intercooler Fan Override Kit

Installation instructions for the X3 Intercooler Fan Override Kit on the Can-Am Maverick X3 (SKU 100FC0024). Parts, tools, and full procedure.

SKU
3002010001
Legacy SKU
100FC0024
Revision
Rev_021821

In the box

Parts and tools

X3 Intercooler Fan Override Kit
X3 Intercooler Fan Override Kit

Included parts

  • 1Fan Override Switch
  • 1Relay
  • 1Switch to Relay/Battery Wire Group
  • 1Fan to Replay Wire Group
  • 110-32 x 1/2" BHCS
  • 2#10 Washers
  • 110-32 Nylon Lock Nut
  • 130 Amp Fuse

Required tools

  • Drill and 3/16” Drill Bit
  • Flat Head Screwdriver

Procedure

Installation

  1. Step 1

    Remove passenger seat.

  2. Step 2

    Remove center tunnel top cover and passenger side cover.

  3. Step 3

    Remove a blank switch knockout. (Figure 1)

    Remove a blank switch knockout.
    Fig. 1
  4. Step 4

    Drill a 3/16” hole in the battery compartment for the relay.

  5. Step 5

    Mount the relay with the supplied 10-32 hardware. (Figure 2)

    Mount the relay with the supplied 10-32 hardware.
    Fig. 2
  6. Step 6

    Feed the wiring harness through the blank switch hole and down the center tunnel to the battery compartment. Connect wiring harness to the ground (-) and positive (+) terminals.

  7. Step 8

    Feed the wires from the fan underneath the engine cover through the back of the firewall to the battery compartment.

  8. Step 9

    Clip the wires into the relay accordingly to the wiring diagram below.

    Clip the wires into the relay accordingly to the wiring diagram below.
    Note: Pin 87a is not used
  9. Step 10

    Replace the 20A fuse with supplied 30A fuse.

  10. Step 11

    Replace all panels and seat.

When you’re done

After installation

Note

The switch will power the fan regardless of ignition position.

Emissions notice. This product is exempt from the emission standards and related requirements of 40 C.F.R. § 1051 as provided by 40 C.F.R. § 1051.620, and California law [e.g., vehicle code §§ 27156 and 38391]. This product is sold only for use in connection with EPA certified, purpose-built, nonroad vehicles used solely for closed course, nonroad competition/racing and not used for any recreational purpose or on public highways or right of ways maintained by and open to the public. This product is sold only in connection with machines that do not fall under state and/or federal noise or emission standards/regulations. Purchasers who/that purchase this product represent and warrant that the product is purchased only in connection with EPA-certified, emission-regulations-exempt and noise-regulations-exempt competition/racing vehicles as interpreted under applicable state and/or federal law.

Need technical support?

Submit a ticket with your vehicle and what you're seeing, and our support team will get back to you.

Contact Support
We use cookies to improve your experience on our website. Read about how we use cookies in our Privacy Policy. By browsing this website, you agree to our use of cookies. privacy policy
accept

Your cart

×
×