BUY NOW, PAY LATER. Starting at 0% APR 
2026 Kawasaki H2 Secondary TAPP Clutch
2026 Kawasaki H2 Secondary TAPP Clutch
In the box
Parts and tools
Included parts
- 1H2 Tapp Secondary
- 1Secondary Washer
- 1LH Secondary Bolt
Required tools
- EVP Belt Changing Tool
- Torque Wrench
- 10, 19mm Socket
Procedure
Installation
- Step 1
Remove the left rear shock. (See service manual Chapter 14- Page 18).
- Step 2
Remove (10) clutch cover bolts and gasket.
- Step 3
Install the (3) M10-1.25 hex bolts into the OEM secondary. Remove the drive belt.
- Step 4
With a 19mm socket and impact driver, remove the secondary clutch bolt.
CautionBOLT IS REVERSE THREAD. RIGHT HAND ORIENTATION TO LOOSEN.
- Step 5
The OEM secondary comes packed full of grease. It is recommended to remove the grease from the shaft and clutch housing.
- Step 6
Install the TAPP secondary onto the shaft, make sure it is fully installed.
- Step 7
Install the supplied TAPP secondary washer and bolt. Torque to 100 ft-lb. THIS IS A LEFT-HANDED THREAD. COUNTERCLOCKWISE TO TIGHTEN.
LOOSEN
Need technical support?
Submit a ticket with your vehicle and what you're seeing, and our support team will get back to you.
