CF Moto Z10 Dual Fan Intercooler Shroud

Begin by removing all of the screws holding the bed on. Also remove intercooler intake. With a T-30

Remove screws around perimeter of intercooler shroud and remove center panel.

Trim a 3/4” square of the plastic shroud around the bottom passenger side of the intercooler. Use a side cutter for this.

Install the fan shroud over the intercooler.

Locate the bottom plate of the intercooler shroud, Adel clamp, and the three flanged hex head bolts.

Install the bottom plate to the intercooler and shroud. Install (3) bolts from topside. The Adel clamp is used to secure the fan leads and is installed on the right side bolt towards the center of the vehicle. Make sure the flange on the bottom plate fits around the backside of the intercooler, the foam strips keep the shroud secure to the intercooler.

Remove center dash panel. Remove passenger seat and small access panel on center console. Seat removes by pulling a strap and tip seat forward and out.

Insert fuel pump side of harness through small access panel and route to open space at front console.

Pull harness up through the hole just behind fuel tank and connect inline between factory harness and fuel pump pigtails.

Pull opposite end of harness through small hole on firewall side of console. Connect positive and negative directly to battery.

Follow OEM harness up with intercooler lead. Attach the Y-Harness adapter to harness and intercooler fans. Attach any loose points of harness with zip-ties.