BUY NOW, PAY LATER. Starting at 0% APR 
Can-Am X3 Water/Oil Separator Catch Can
Installation instructions for the X3 Water/Oil Separator Catch Can on the Can-Am Maverick X3 (SKU 803FC0001). Parts, tools, and full procedure.
In the box
Parts and tools
Included parts
- 1Oil/Water Separator w/ Drain Valve Attached
- 1Silicone Cap
- 227.1mm Pinch Clamp
- 1Pre-Filter
- 20-32 Worm Drive Clamp
Required tools
- 1/4" Socket or Flat Head Screwdriver
- 6mm Allen Wrench
- Side Cutters or Pinch Clamp Tool
Procedure
Installation Steps
- Step 1
Remove valve cover breather hose from V-flow using a 1/4" socket or flat head screwdriver (see figure 1)
Fig. 1 - Step 2
Install supplied Silicone cap onto barb fitting on the V-Flow and secure using (1) 27.1mm pinch clamp.
- Step 3
Using a 6mm Allen wrench and secure the catch can to the frame (See Figure 2)
Fig. 2 - Step 4
Install Pre-Filter onto the air filter, then install onto the top of the catch can.
- Step 5
Install the valve cover breather hose onto the side port of the catch can and secure it in place using (1) 27.1mm pinch clamp (See Figure. 3)
Fig. 3
When you’re done
After installation
Please make sure to drain canister periodically.
- When using alcohol-based fuels such as E85, drain the canister daily.
When tightening valve, make sure to lightly seat, or O-Ring will tear.
Need technical support?
Submit a ticket with your vehicle and what you're seeing, and our support team will get back to you.
