BUY NOW, PAY LATER. Starting at 0% APR 
Can-Am X3 Torrent-F Intake Plenum
X3 Torrent-F Intake Plenum
In the box
Parts and tools
Included parts
- 1Torrent-F Intake Plenum
- 1Hardware/O-Rings Kit
Required tools
- 8, 13mm Socket
- 13mm Open End Wrench
- T-30 Torx
- Di Electric Grease
- Torque Wrench
- Spring Puller
Procedure
Installation Steps
- Step 1
Use the T-30 Torx and remove the bolts holding the rear valance on.
- Step 2
Remove spring holding the muffler and the cat pipe together.
- Step 3
Using the 13mm wrench and 13mm socket remove the 4 bolts holding the muffler on and remove it.
- Step 4
Remove the exhaust vent on the clutch box to help have room to get to the plenum.
- Step 5
Remove the charge tube from the throttle body.
- Step 6
Unplug the Map sensor.
- Step 7
Disconnect the fuel line from the fuel rail.
- Step 8
Using the T-30 or 8mm remove the fuel rail from the plenum.
- Step 9
Using the T-30 or 8mm remove the 8 bolts holding the plenum onto the car.
- Step 10
Install the OEM gasket and head spacers onto the new plenum.
- Step 11
Install the big O-ring on the side for the throttle body again use di electric grease.
- Step 12
Install throttle body onto the new plenum, make sure the plug is facing towards the engine and using the M6 x 1 x 45 bolts to fasten it on.
- Step 13
Install the map sensor and use di electric on the O-ring use the M6 x 1 x 16 and fasten it on.
- Step 14
Install the new plenum, using the stock bolts.
- Step 15
Torque the bolts to the correct specs.
TIGHTENING TORQUE. Intake manifold screws 9 N•m ± 1 N•m (80 lbf•in ± 9 lbf•in) - Step 16
Install fuel rail using the provided bolts and connect the fuel line.
- Step 17
Plug in map sensor.
- Step 18
Plug in throttle body.
- Step 19
Connect the blow off valve to the open port.
- Step 20
Reinstall the clutch vent tube.
- Step 21
Reinstall the exhaust.
- Step 22
Reinstall the rear valance.
Need technical support?
Submit a ticket with your vehicle and what you're seeing, and our support team will get back to you.
