Can-Am X3 Torrent-B Billet Intake Plenum Assembly

Use the T-30 Torx and remove the bolts holding the rear valance on.

Remove spring holding the muffler and the cat pipe together.

Using the 13mm wrench and 13mm socket remove the 4 bolts holding the muffler on and remove it.

Remove the exhaust vent on the clutch box to help have room to get to the plenum.

Remove the charge tube from the throttle body.

Unplug the Map sensor.

Disconnect the fuel line from the fuel rail.

Using the T-30 or 8mm remove the fuel rail from the plenum.

Using the T-30 or 8mm remove the 8 bolts holding the plenum onto the car.

Install the 3 O-rings on the runners, use di electric grease on the O-rings to get them seated correctly in the groove.

Install the big O-ring on the side for the throttle body. Use di electric grease.

Install throttle body onto the new plenum, make sure the plug is facing towards the engine and using the M6 x 1 x 45 bolts to fasten it on.

Install the map sensor and use di electric on the O-ring use the m6x1x16 and fasten it on.

Install the new plenum, using the OEM 8 bolts.

Torque the bolts to the correct specs.

• Torque9 N•m ± 1 N•m (80 lbf•in ± 9 lbf•in)Intake manifold screws

Install fuel rail using the provided bolts and connect the fuel line.

Plug in map sensor.

Plug in throttle body.

Connect the blow off valve to the open port.

Reinstall the clutch vent tube.

Reinstall the exhaust.

Reinstall the rear valance.

Remove both clutches.

Remove (8) bolts holding the rear CVT cover to the motor.

In the photo below, with a Dremel sand away where the blue box is. Doing this will allow room for the throttle body. DO NOT remove the clip. DO NOT sand all the way through the cover or it won’t be watertight.

Re assemble the CVT box and clutches once there is enough clearance.