BUY NOW, PAY LATER. Starting at 0% APR 
Can-Am X3 Billet Shift Knob
Installation instructions for the X3 Billet Shift Knob on the Can-Am Maverick X3 (SKU 925FC0005). Parts, tools, and full procedure.
In the box
Parts and tools
Included parts
- 1EVP Billet Shift Knob
Required tools
- 13mm Open End Wrench
- Medium Strength Thread Lock
Procedure
Installation Steps
- Step 1
Use your 13mm wrench to loosen the jamb nut underneath the stock shift handle.
- Step 2
Turn the factory shift knob counterclockwise to remove.
NoteThe handle was installed with thread lock and may require some leverage to loosen.
- Step 3
Turn the jamb nut down to the bottom of the shift lever.
- Step 4
Use a small amount of medium strength thread lock and thread the EVP Shift Knob onto the shaft until it lightly seats.
- Step 5
Position the EVP Knob so it comfortably fits your hand then tighten the jamb nut.
Emissions notice. This product is exempt from the emission standards and related requirements of 40 C.F.R. § 1051 as provided by 40 C.F.R. § 1051.620, and California law [e.g., vehicle code §§ 27156 and 38391]. This product is sold only for use in connection with EPA certified, purpose-built, nonroad vehicles used solely for closed course, nonroad competition/racing and not used for any recreational purpose or on public highways or right of ways maintained by and open to the public. This product is sold only in connection with machines that do not fall under state and/or federal noise or emission standards/regulations. Purchasers who/that purchase this product represent and warrant that the product is purchased only in connection with EPA-certified, emission-regulations-exempt and noise-regulations-exempt competition/racing vehicles as interpreted under applicable state and/or federal law.
Need technical support?
Submit a ticket with your vehicle and what you're seeing, and our support team will get back to you.
