BUY NOW, PAY LATER. Starting at 0% APR 
Can-Am X3 Billet Aluminum Boost Recirculating Valve (BRV) Kit
X3 Billet Aluminum Boost Recirculating Valve (BRV) Kit
In the box
Parts and tools
Included parts
- 1EVP Boost Recirculating Valve
- 11” Hose x 3”
- 13/4" Hose x 23”
- 432-20mm Worm Drive Clamps
- 1“Y” 3/4”x3/4’x3/4” Hose Fitting
- 1Straight 3/4"-3/4” Fitting
- 1Straight 1”-3/4” Fitting
- 1Zip Tie
- 240-25mm Worm Gear
Required tools
- 8, 10, 11mm Socket
Procedure
Installation Steps
- Step 1
Remove intercooler.
- Step 2
Remove charge tube from turbo to intercooler.
- Step 3
Remove the crank case vent line and fitting from the v-flow intake.
- Step 4
Install the Y fitting into the v-flow intake. (See figure 1)
Fig. 1 NoteOnly if you do NOT have a catch-can already installed on the car. If you have a catch can installed use the 3/4"-3/4” straight.
- Step 5
Route the crank case vent line over the long charge tube and connect it to the v-flow. (Figure 2)
Fig. 2 - Step 6
If you do NOT have a catch can installed and used the “Y” fitting, connect the crank case vent and Boost Recirculating Valve to the “Y” Fitting.
Crank case vent line connected to the V-Flow intake. - Step 7
(See figure 2). Connect the 3”x1” hose to the BRV. Connect the 1”-3/4” adaptor to the 1” hose. Connect the 23” x 3/4" hose to the adaptor. The other end is already connected to the V Flow.
- Step 8
Connect the short side of the BRV into the charge tube. Tighten down with a 32-20mm worm drive.
- Step 9
Reinstall the intercooler, connect both charge tubes to the intercooler, reconnect the fan harness to the intercooler. Tighten down.
Need technical support?
Submit a ticket with your vehicle and what you're seeing, and our support team will get back to you.
