In the box
Parts and tools
Included parts
- Secondary Holding Tool
- Secondary Helix Wrench
- Step 1
This can be done on the bench or installed on the vehicle.
- Step 2
Thread belt changing tool into clutch 2-3 turns.
- Step 3
Extend belt changing tool, this will apply a small amount of pressure to helix cap.
- Step 4
Loosen the (3) M5 Allen bolts just enough to clear the cap. The spring will remain under tension, keep pressure on the helix wrench.
- Step 5
Hold the helix cap securely with the smaller wrench while using the large holding tool to grip one of the helix fingers. Loosen the three M5 Allen bolts just enough for the helix cap to rotate freely. The spring will remain under tension during this process. Adjust the spring preload to the desired setting, then re-tighten the helix cap and torque the three M5 Allen bolts
Emissions notice. This product is exempt from the emission standards and related requirements of 40 C.F.R. § 1051 as provided by 40 C.F.R. § 1051.620, and California law [e.g., vehicle code §§ 27156 and 38391]. This product is sold only for use in connection with EPA certified, purpose-built, nonroad vehicles used solely for closed course, nonroad competition/racing and not used for any recreational purpose or on public highways or right of ways maintained by and open to the public. This product is sold only in connection with machines that do not fall under state and/or federal noise or emission standards/regulations. Purchasers who/that purchase this product represent and warrant that the product is purchased only in connection with EPA-certified, emission-regulations-exempt and noise-regulations-exempt competition/racing vehicles as interpreted under applicable state and/or federal law.
SKU 4002990011, 4002990010; 4002990011 (Holding Tool), 4002990010 (Helix Wrench)