BUY NOW, PAY LATER. Starting at 0% APR 
Reminder: It may not be legal to drive your side by side in certain areas without a spark arrestor. It is the customers responsibility to see what their local laws and regulations are.
Sea-Doo Spark Arrestor Installation
Spark Arrestor Installation
In the box
Parts and tools
Included parts
- 1EVP Spark Arrestor
Required tools
- 5mm Allen Wrench
Procedure
Installation
- Step 1
Make sure the vehicle is cold and in park.
- Step 2
You will find the spark arrester on the exhaust exit, remove the 5mm Allen.
- Step 3
Place the new spark arrestor into the exhaust and tighten the 5mm Allen.
Procedure
For Defender Spark Arrestor
- Step 1
Make sure the vehicle is cold and in park.
- Step 2
Open the utility box.
- Step 3
Remove the (3) bolts holding the exhaust tip on. Remove the exhaust tip and gasket.
- Step 4
Inside the exhaust tip, you will find the spark arrestor. Replace the spark arrestor.
- Step 5
Install the gasket and (3) bolts mounting the tip to the muffler.
- Step 6
Close the utility box.
When you’re done
After installation
Note
After installing your new muffler, run the vehicle for at least 10 minutes without the spark arrestor screen installed. This is to make sure that any loose fibers that are left inside the muffler during the manufacturing process are cleared out of the system. Please re- install after this clean out period.
Need technical support?
Submit a ticket with your vehicle and what you're seeing, and our support team will get back to you.
