BUY NOW, PAY LATER. Starting at 0% APR 
Polaris Pro XP V-Flow Intake Kit
Pro XP V-Flow Intake Kit
In the box
Parts and tools
Included parts
- 1V-Flow Intake
- 432-20 Worm Drive Clamp
- 290-Degree Elbow
Required tools
- 7mm Socket
- 11mm Socket Deep Well
- Side Cutters
- T30 Socket
- Di Electric Grease
Procedure
Installation Steps
- Step 1
Remove (4) T30 bolts on the back of the bed and take out the bed.
- Step 2
Remove heat shield over the turbo.
- Step 3
Use a side cutter, cut the clamps holding the crank case vent and the recirculating valve tube into the intake tube.
- Step 4
Using an 11mm deep-well socket loosen the clamps holding the intake boot to the air box and at the turbo.
- Step 5
Unplug the map sensor and remove the intake tube.
- Step 6
Using the T30 remove the map sensor.
- Step 7
Put a small amount of di-electric grease on the O-ring in the map sensor and install it in the new intake tube. Use the M6 bolt to secure it.
- Step 8
Install the 90-degree elbows into the intake tube. For a better fit cut about 1” lower than the bend in the factory hose.
NoteIf you are using a blow-off valve and/or a catch can you will NOT use the 90-degree elbows.
- Step 9
Install the intake tube using the OEM clamps and tighten them down and plug in the map sensor.
- Step 10
Reinstall the heat shield and the bed.
Need technical support?
Submit a ticket with your vehicle and what you're seeing, and our support team will get back to you.
