In the box
Parts and tools
Included parts
- 1EVP Breather Tube
- 113.3mm Pinch Clamp
- 1Pro R Catch Can Assembly
- 222mm Pinch Clamps
- Step 1
Install the catch can on the left-rear frame. Tighten down the clamp around the tube frame. The port on the cap will face the engine bay. Install the 1/4" rubber hose to the barb located on the bottom of the catch can. Run it down into the belly pan.
- Step 2
Locate the engine breather hose going to the plenum (which is currently removed). Remove the hose from the engine. Remove the longer piece of hose. Keep the small piece with the connector and one-way-ball valve. Reconnect the small piece to the engine.
- Step 3
Install the catch can hose. The “Y” portion of the hose will go to the small connector on the engine and the valve cover.
- Step 4
If you’re NOT running a blow off valve, install supplied 5/16” cap and 13.3mm pinch clamp on the plenum brass quick disconnect.
Emissions notice. This product is exempt from the emission standards and related requirements of 40 C.F.R. § 1051 as provided by 40 C.F.R. § 1051.620, and California law [e.g., vehicle code §§ 27156 and 38391]. This product is sold only for use in connection with EPA certified, purpose-built, nonroad vehicles used solely for closed course, nonroad competition/racing and not used for any recreational purpose or on public highways or right of ways maintained by and open to the public. This product is sold only in connection with machines that do not fall under state and/or federal noise or emission standards/regulations. Purchasers who/that purchase this product represent and warrant that the product is purchased only in connection with EPA-certified, emission-regulations-exempt and noise-regulations-exempt competition/racing vehicles as interpreted under applicable state and/or federal law.
SKU 1561020002; 803FU0011