BUY NOW, PAY LATER. Starting at 0% APR 
Can-Am Maverick R Upper Scoop and Bed Removal
Installation instructions for the Maverick R Upper Scoop and Bed Removal on the Can-Am Maverick R. Parts, tools, and full procedure.
In the box
Parts and tools
Required tools
- 8, 10mm Socket
- T-30 Socket
- Panel Removal Tool
Procedure
Installation
- Step 1
Remove the bed bolts: (4) T-15 x 16mm screws for plastic, (6) T-30 x 40mm screws with washers, (2) T-30 x 70mm screws with 2 washers and nut, (2) push dart.
- Step 2
Remove (6) push darts on the lower trim of scoop.
- Step 3
With a panel tool, remove the back half of trim.
- Step 4
On the roof, remove (1) T-30 screw holding the upper dam shim and (7) T-20 to remove tunnel access panel.
- Step 5
On the inside of the cab, remove the lower wind dam block off (4) clips. Remove (2) T-30 screws holding the lower wind dam.
- Step 6
Behind the lower wind dam block off plate will be (5) 8mm screws. Once removed you can remove the upper trim piece.
- Step 7
On the roof, underneath the tunnel access panel you will find (2) T-20 bolts with (2) 8mm nuts below in the cab. Remove.
- Step 8
You can now remove the upper scoop, lower wind dam and bed.
Need technical support?
Submit a ticket with your vehicle and what you're seeing, and our support team will get back to you.
