In the box
Parts and tools
Included parts
- Micro Fuel Pressure Regulator
- Step 1
Remove center panel from dash, lightly pry with a trim panel tool.
- Step 2
Once panel is removed, disconnect fuel line by pressing inward on green tabs and pulling up, disconnect harness.
- Step 3
Unthread fuel pump retaining nut and pull fuel pump assembly out. Tilt fuel pump when removing, be careful not to break sending unit arm.
- Step 4
Slide regulator retaining clip out from pump housing and pull regulator up and out of housing. Make sure the O-ring is not left in the housing.
- Step 5
Press new regulator into housing, a thin layer of dielectric grease on O-ring will help with installation. Install clip back into housing to hold regulator in place. Slide fuel pump back into tank be sure to line arrow up with line on tank, tighten nut and reconnect fitting and wire harness.
Emissions notice. This product is exempt from the emission standards and related requirements of 40 C.F.R. § 1051 as provided by 40 C.F.R. § 1051.620, and California law [e.g., vehicle code §§ 27156 and 38391]. This product is sold only for use in connection with EPA certified, purpose-built, nonroad vehicles used solely for closed course, nonroad competition/racing and not used for any recreational purpose or on public highways or right of ways maintained by and open to the public. This product is sold only in connection with machines that do not fall under state and/or federal noise or emission standards/regulations. Purchasers who/that purchase this product represent and warrant that the product is purchased only in connection with EPA-certified, emission-regulations-exempt and noise-regulations-exempt competition/racing vehicles as interpreted under applicable state and/or federal law.
SKU 2532990005