BUY NOW, PAY LATER. Starting at 0% APR 
Can-Am 2020+ Defender Magnum Slip-On Exhaust
2020+ Defender Magnum Slip-On Exhaust
In the box
Parts and tools
Included parts
- 1EVP Defender Slip-On Exhaust Kit
- 1Optional Tip
Required tools
- 13,17mm Socket
- 13mm Wrench
- Flat blade Screwdriver
Procedure
Installation Steps
- Step 1
Open the dump box and disconnect the shock by removing the coder pin and pin. This will allow a few more inches of space while installing the exhaust.
- Step 2
Loosen the clamp on heat shield with a flat blade screwdriver, you do not need to remove this clamp.
- Step 3
Loosen the exhaust clamp from the header pipe, joining the OEM muffler.
- Step 4
Loosen (2) bolts holding the OEM muffler in place. You will need a 13mm socket and open-end wrench.
Noteon the drivers side you will see a rubber gromet and aluminum bushing, keep this for installation.
- Step 5
Once everything is loose, remove the OEM muffler.
- Step 6
Place the new supplied exhaust clamp onto the new EVP magnum exhaust before installing. (Figure 1)
Figure 1 - Step 7
Install the Magnum muffler into the car, push the magnum into the header pipe until the (2) securing bolt holes line up. (Figure 2)
Figure 2 - Step 8
Install the (2) 13mm head socket bolts securing the Magnum back into position. Keep them hand tight for now.
- Step 9
Install the flame arrestor into the Magnum exhaust. (Figure 3)
Figure 3 - Step 10
Install the exhaust gasket.
Figure 4 NoteMake sure the indent goes on the flame arrestor side. (See figure 4)
- Step 11
Grab the Magnum tip and (3) supplied bolts and mount the tip onto the Magnum. Hand tighten the nuts on the back side. (Figure 5)
Figure 5 - Step 12
Once everything is together, go back through and tighten everything from the heat shield, exhaust clamp, (2) securing bolts on the Magnum, and (3) bolts securing the exhaust tip on.
- Step 13
Reconnect the shock to the rear cargo box.
Need technical support?
Submit a ticket with your vehicle and what you're seeing, and our support team will get back to you.
