BUY NOW, PAY LATER. Starting at 0% APR 
Can-Am 2020-2021 X3 Charge Tube Kit
2020-2021 X3 Charge Tube Kit
In the box
Parts and tools
Included parts
- 1EVP Silicone Charge Tube Set
- 1T Bolt Clamp 206
- 3T Bolt Clamp 262
- 113.3mm Pinch Clamp
- 140-25mm Worm Drive Clamp
- 1Blow-Off Valve Block Off
- 1Aux Port Block Off
- 212” Zip Ties
Required tools
- Screwdriver(s)
- T-30 Torx Bit
- Side Cutters
- Spring Tool for Exhaust (optional)
Procedure
EVP Charge Tube Installation
- Step 1
Remove rear exhaust valance and remove factory muffler (it makes the job much easier!)
- Step 2
Remove the plastic access cover between the two seats to see the engine/turbocharger.
- Step 3
Remove the OEM charge tubes by loosening the worm drive clamps that secure them to the factory turbocharger, intercooler and throttle body. You will need to cut the zip ties that hold the two smaller diameter hoses to the charge rear charge tube.
- Step 4
Install new EVP charge tubes in the same location using T bolt clamps on the intercooler and throttle body. Use the 262 T-Bolt clamps on both sides of the intercooler and on the throttle body. Use the 206 clamp on the turbocharger. Tighten all clamps.
- Step 5
At this time, it is a good idea to tighten the OEM clamps on both sides of the throttle body – these can pop off with higher boost.
- Step 6
Install EVP billet Blow-Off Valve (BOV) block off if not installing the EVP BOV currently. Secure the block off with the worm drive clamp that came in the kit.
NoteOn 2021 X3’s, adjust the coolant lines so they don’t rub on the BOV.
- Step 7
Use supplied zip ties to hold the smaller diameter hoses to the EVP charge tube. Reinstall exhaust and all covers.
Need technical support?
Submit a ticket with your vehicle and what you're seeing, and our support team will get back to you.
