BUY NOW, PAY LATER. Starting at 0% APR 
Can-Am 2017-2019 X3 Charge Tube Kit
2017-2019 X3 Charge Tube Kit
In the box
Parts and tools
Included parts
- 1EVP Silicone Charge Tube Set
- 2T Bolt Clamp 250
- 1T Bolt Clamp 206
- 1T Bolt Clamp 262
- 114.5mm Pinch Clamp
- 125-40 Worm Drive Clamp
- 1BOV Port Block Off
- 1Aux Port Block Off
- 212” Zip Ties
Required tools
- Screwdriver(s)
- T-30 Torx Socket
- Spring Tool for Exhaust (optional)
- Side Cutters
Procedure
Installation Steps
- Step 1
Remove rear exhaust valance and remove factory muffler (it makes the job much easier!)
- Step 2
Remove the plastic cover between the two seats to access the engine/turbocharger.
- Step 3
Remove the OEM charge tubes by loosening the worm drive clamps that secure them to the factory turbocharger, intercooler and throttle body. You will need to cut the zip ties that hold the two smaller diameter hoses to the charge rear charge tube.
- Step 4
Install new EVP charge tubes in the same location using T bolt clamps on the intercooler and throttle body. Use the 250 clamps on both sides of the intercooler and the 262 on the throttle body. Use the 206 clamp on the turbo charger. Tighten all clamps.
- Step 5
At this time, it is a good idea to tighten the OEM clamps on both sides of the throttle body – these can pop off with higher boost.
- Step 6
Install the Auxiliary port block off into the small open port of the charge tube unless you are using this for a boost gauge port. Use the supplied 14.5mm pinch clamp to secure.
- Step 7
Install EVP billet Blow-Off Valve (BOV) block off if not installing the EVP Blow-Off Valve (BOV) at this time. Secure the block off with the worm drive clamp that came in the kit.
- Step 8
Use supplied zip ties to hold the smaller diameter hoses to the EVP charge tube. Reinstall exhaust and all covers
Need technical support?
Submit a ticket with your vehicle and what you're seeing, and our support team will get back to you.
