BUY NOW, PAY LATER. Starting at 0% APR 
2014+ Sea Doo Spark SeaDek Traction Mats
Installation instructions for the 2014+ Sea Doo Spark SeaDek Traction Mats on the 2014+ Sea-Doo Sea-Doo. Parts, tools, and full procedure.
In the box
Parts and tools
Included parts
- 1Traction Mat Kit
Required tools
- Alcohol 90%
- Rag/ Microfiber
- Heat Gun
Procedure
Installation
- Step 1
With compressed air blow out debris and water from your tunnels.
- Step 2
With alcohol scrub your entire tunnels and back deck.
- Step 3
If you have a Trixx it is recommended to remove the foot stomp pads with a heat gun.
- Step 4
It is best to lay out all your traction mats to get an idea of where you want everything to line up. Below is a diagram.
- Step 5
Once ready to stick, peel the backing off and lay. Press firmly on the traction mats and around all edges.
Emissions notice. This product is exempt from the emission standards and related requirements of 40 C.F.R. § 1051 as provided by 40 C.F.R. § 1051.620, and California law [e.g., vehicle code §§ 27156 and 38391]. This product is sold only for use in connection with EPA certified, purpose-built, nonroad vehicles used solely for closed course, nonroad competition/racing and not used for any recreational purpose or on public highways or right of ways maintained by and open to the public. This product is sold only in connection with machines that do not fall under state and/or federal noise or emission standards/regulations. Purchasers who/that purchase this product represent and warrant that the product is purchased only in connection with EPA-certified, emission-regulations-exempt and noise-regulations-exempt competition/racing vehicles as interpreted under applicable state and/or federal law.
Need technical support?
Submit a ticket with your vehicle and what you're seeing, and our support team will get back to you.
