Can-Am X3 Big Injectors, Set of 3

Use compressed air to blow out debris around the fuel rail and injector seats.

Using a T30 Torx socket, remove the two Torx screws securing the fuel rail to the plenum.

Lift the fuel rail upward and back (without removing the injectors) – this will make it easier to disconnect injector plugs. Squeeze the retainer clips to release the plugs from injectors and remove.

Move the fuel rail to the passenger side of the engine so it is easier to work on. Use a small flat blade screwdriver to remove the injector clips, securing the injectors to the fuel rail. Make note of their orientation as they will be installed the same on the new injectors.

Apply di electric (silicone) grease on the top and bottom O-rings of the new injectors.

Install the injectors into the fuel rail in the same orientation as they were removed.

Reinstall clips making sure they are installed onto the injectors in the groove the same as they were on the OEM injectors.

Reconnect injector plugs and harness adapter.

Reinstall fuel rail hold down bolts – DO NOT OVERTIGHTEN!

Push start button, but do not start the engine – check for fuel leaks – if there is any leaking of fuel from the injectors or fuel rail, this must be addressed prior to running the engine!!