In the box
Parts and tools
- Step 1
Remove engine access panel and knee panel on the left side of the hull.
- Step 2
Through the engine access panel, disconnect the steering control (20 pin) plug and if equipped IBR (6 pin) plug. Do not use a screwdriver to pry off.
- Step 3
Underneath the handlebars, through the knee panel you will locate the steering linkage. Remove the linkage with (2) 10mm sockets. Remove the steering linkage brace by removing (2) T30 head screws.
- Step 4
Once the steering linkage is loose, push it into the engine bay.
- Step 5
Remove the seat. Remove the (3) T30 screws around the fuel fill. Leave cap on.
- Step 6
With a T30 socket, remove 23 screws holding the upper hull (black portion) on. (10) screws have a locknut underneath the lower hull. Use a 10mm socket.
When you’re done
After installation
Reinstall the hull in reverse order.
Emissions notice. This product is exempt from the emission standards and related requirements of 40 C.F.R. § 1051 as provided by 40 C.F.R. § 1051.620, and California law [e.g., vehicle code §§ 27156 and 38391]. This product is sold only for use in connection with EPA certified, purpose-built, nonroad vehicles used solely for closed course, nonroad competition/racing and not used for any recreational purpose or on public highways or right of ways maintained by and open to the public. This product is sold only in connection with machines that do not fall under state and/or federal noise or emission standards/regulations. Purchasers who/that purchase this product represent and warrant that the product is purchased only in connection with EPA-certified, emission-regulations-exempt and noise-regulations-exempt competition/racing vehicles as interpreted under applicable state and/or federal law.